NI Multisim Circuit Designing

The course objective is to learn schematic drawings, and simulation of Electronics prototypes, by working with instruments, analyses for simulating Electronics designs, designing motherboards.

11

 3h 43m | 25 Videos | 68080 Views |   Intermediate

Multisim Circuit Designing:

This training will help you learn about the National Instruments software Multisim to study and evaluate the performance of circuits. Throughout this training the learners shall understand about circuit designing, simulation and performing analysis on the circuits. By the end of this training you shall be able to perform analysis of circuits more effectively and also understand its working practically.

The course objective is to learn schematic drawings, and simulation of Electronics prototypes, by working with instruments, analyses for simulating Electronics designs, designing motherboards

Table of Contents

Course 1 – Introduction and Understanding standard menus, toolbars

Course 2 – Drawing a Schematic

• Sheet properties
• Global preferences
• Placing and Wiring Components, Inserting Buses
• Inserting title block/s
• Adding sub-circuits

Course 3 – Working with Instruments

• Virtual instruments such as Multimeters, Oscilloscopes etc…..
• Measurement probes
• Logic analyzers and converters

Course 4 – Understanding MCU (Microprocessor Control units)

• Microcontrollers such as 80X and PIC
• RAM chips
• Integrating and designing motherboards

Course 5 – Working with Analyses

• AC/DC transient analysis
• Fourier analysis
• Distortion and Noise analysis
• Sensitivity analysis

Course 6 – Working with Results

• Precision measurements
• Post processing

Target Customers:

• Electronics engineers/students
• Electrical engineering graduates
• Working Professionals from electronics industry
• Students looking learning Multisim for the first time

Pre-Requisites:

• Multisim software
• Basic understanding of electronics
• Knowledge of using computers
• Engineering managers

Back to top ▴